To create a Monitor
Resources task,
perform the following steps.
Note: For all the details about options and fields displayed
in the panels, see the online help by clicking the question mark located
at the top-right corner of each panel.
Procedure
In the navigation bar, click System Status
and Health > Workload Monitoring > Monitor Workload and
follow the steps described in Creating a monitoring task query.
If you are familiar with conman, in the Query text
box specify a query based on the conman showresources syntax.
Alternatively, click Edit to select the filter
criteria from the list of options that is displayed.
In the General Filter section, specify some broad filtering
criteria to limit the results retrieved by your query. Here you start
refining the scope of your query by also considering the amount of
information you want to retrieve. Optionally, in some of the results
tables in the Periodic Refresh Options section, you can customize
how often to refresh the information by specifying the refresh interval
in seconds in hh:mm:ss format, with a minimum of 30 seconds and a
maximum of 7200 seconds. For example, 00:01:10 means 70 seconds. If
the value specified is not valid, the last valid value is automatically
used. If the periodic refresh is enabled for a task, when the task
runs, the refresh time control options are shown in the results table.
You can also set or change the periodic refresh interval directly
in the results table when the timer is in stop status. In this case,
the value specified at task creation time is temporarily overwritten. You can filter
the task results based on the resource and workstation names, or part
of names (using wildcard characters). You can also configure the automatic
refresh of the task results in the table.
In the Columns Definition section, select the information
you want to display in the table containing the query results. According
to the columns you choose here, the corresponding information is displayed
in the task results table. For example, for all the resources resulting
from your query, you might want to know if they are in use and the
associated workstations. You can then drill down into this information
displayed in the table and navigate it. In the Columns Definition
panel, not only can you select the columns for this task results,
but you can also specify the columns for secondary queries
on jobs, job streams, and workstations. For example, you are creating
a task to search for all the resources whose names start with the
same characters. From the resulting list of resources, you can navigate
to see (secondary query) a list of all the jobs that use each of them.
Starting from the Monitor
Resources task
results table, you can start further queries on secondary objects
associated to one of the resources in the table; the information to
be retrieved with these secondary queries is specified in this panel.
Results
After specifying all the required criteria, you can save your
task or immediately run it to create a list of resources that satisfies
your filtering settings. For details, see Creating a monitoring task query.